Exit Inspection-Electrical: Rough - Builder Academy

ELECTRICAL: ROUGH

Exit Inspection

Project

Builder

Inspection date

Temporary power pole is set and temporary power is on.

Yes/Pass/True No/Fail/False NA See Notes

Panel box is of size and at location as specified.

Yes/Pass/True No/Fail/False NA See Notes

Wiring is complete for light switches and receptacles per plan.

Yes/Pass/True No/Fail/False NA See Notes

Range is wired for electric and plumbed for gas.

Yes/Pass/True No/Fail/False NA See Notes

Range Hood/Microwave wiring is in per plans.

Yes/Pass/True No/Fail/False NA See Notes

Fluorescent lights are in (recessed and/or surface) per plan.

Yes/Pass/True No/Fail/False NA See Notes

Recessed can lights are in per plan.

Yes/Pass/True No/Fail/False NA See Notes

Telephone jacks are located per plan.

Yes/Pass/True No/Fail/False NA See Notes

Electric connection has been run to fireplace location(s).

Yes/Pass/True No/Fail/False NA See Notes

Television jacks are in per plan.

Yes/Pass/True No/Fail/False NA See Notes

Low-volt connection has been run to fireplace location(s).

Yes/Pass/True No/Fail/False NA See Notes

Door bell transformer, button(s), bells are installed.

Yes/Pass/True No/Fail/False NA See Notes

Wiring for smoke detectors is installed.

Yes/Pass/True No/Fail/False NA See Notes

Wiring for thermostats is complete.

Yes/Pass/True No/Fail/False NA See Notes

Structured wiring, if requested, is installed.

Yes/Pass/True No/Fail/False NA See Notes

Attic/crawl space light and switch are installed.

Yes/Pass/True No/Fail/False NA See Notes

Whirlpool bath switch, GFI, circuit/wire size, ground wire (if required) are installed.

Yes/Pass/True No/Fail/False NA See Notes

Four wire at range and dryer, of code-required size, is installed.

Yes/Pass/True No/Fail/False NA See Notes

Wires are secured and protected from damage by subsequent work.

Yes/Pass/True No/Fail/False NA See Notes

All receptacle boxes are set square, plumb, and 3/8 inch past stud.

Yes/Pass/True No/Fail/False NA See Notes

Bracing for ceiling fans, as required, is installed.

Yes/Pass/True No/Fail/False NA See Notes

Wiring for outside receptacles is complete.

Yes/Pass/True No/Fail/False NA See Notes

Exterior GFIs and light locations are installed.

Yes/Pass/True No/Fail/False NA See Notes

Wiring for HVAC units is complete.

Yes/Pass/True No/Fail/False NA See Notes

AC disconnect location is as specified.

Yes/Pass/True No/Fail/False NA See Notes

Outside disconnects are installed.

Yes/Pass/True No/Fail/False NA See Notes

Breaker box is installed.

Yes/Pass/True No/Fail/False NA See Notes

Garage wiring (if applicable) is installed.

Yes/Pass/True No/Fail/False NA See Notes

Crossover locations, j-boxes, circuits are installed and clearly marked.

Yes/Pass/True No/Fail/False NA See Notes

Crossovers permanently marked on wire and j-box.

Yes/Pass/True No/Fail/False NA See Notes

Inspection has been passed.

Yes/Pass/True No/Fail/False NA See Notes

Photos of rough electric in each wall have been taken, documented and are in the job binder.

Yes/Pass/True No/Fail/False NA See Notes

Site and house are clean and free of debris.

Yes/Pass/True No/Fail/False NA See Notes

Send to

Builder representative

Builder email

Copy to (optional)

Subcontractor

Subcontractor representative

Subcontractor email (optional)

When the “Send Inspection Report” button is selected, an email with all the information in this Inspection Report will be sent to the “Builder email” address of the Company Representative completing this report and to the “Subcontractor email” address and “Copy to” addresses if provided.

Copyright © 2012-2024 Builder-Resources.com and Builder-Academy.com. All rights reserved. Used by permission.

My Cart

0

Discount

Add Coupon Code

Subtotal

Total Installment Payments

Bundle Discount

0